1999 ... EscaladeManus:
dlc.png [ 3.21 KB | Vaadatud 13500 korda ]
Note: Before starting this procedure, have each of the transmitters that you intend to program ready. All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
On some model years you will be allowed to program a maximum of four transmitters. When reprogramming the remote control door lock receiver, ALL transmitters must be programmed at this time in order for the transmitters to operate the vehicle. Transmitters not programmed at this time will not work and the procedure will have to be redone with all the transmitters present.
Reprogramming Transmitter - BASE (1999/2000)
1. Turn Ignition Switch to OFF.
2. With a fused jumper wire (a 3 amp inline fuse is adequate) ground pin 4 (BLK-Ground) to pin 8 (BLK/WHT-Keyless Entry Program Enable Signal) of the Data Link Communications Connector (a.k.a. DLC, Under the left-hand side of the instrument panel, left side of the steering column, mounted to the bottom of the knee bolster). The receiver will respond by locking and unlocking the doors, and activating the liftgate window release (if equipped) within 2 seconds.
3. Press and hold the LOCK and UNLOCK buttons simultaneously on the first transmitter to be programmed until the locks cycle (approximately 10 seconds).
4. Repeat step for up to four total transmitters to be programmed (if available). The receiver will respond by locking and unlocking the doors and activating the liftgate window release (if equipped) within 2 seconds.
5. Remove the ground applied to the DLC.
6. Lock and unlock the doors in order to verify the transmitter operation.
7. Activate the rear window release in order to verify the transmitter operation.
Repeat programming procedure or replace transmitters as necessary.
Reprogramming Transmitter - ALTERNATE (1999/2000)
1. Turn the ignition to the RUN position, then back to the OFF position. This will disarm the theft-deterrent system.
2. Remove the RADIO fuse (Fuse 17).
3. Turn the ignition from the OFF position to the RUN position three times quickly, within five seconds. The vehicle will respond by locking the doors, unlocking the driver's doors and releasing the tailgate or panel doors. The transmitter is now ready to match to the vehicle.
4. Press and hold the LOCK and UNLOCK buttons on the first transmitter for 15 seconds. The vehicle will respond as in step 3.
5. Repeat step 4 for the remaining transmitters.
6. Replace the RADIO fuse.
7. Check that all transmitters work by pressing their buttons.
Reprogramming Transmitter - Model Year 2002 and Newer
1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the door unlock switch.
4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation.
Tänud Anthony W Haukap